How to Repair a Deadbolt Lock Yourself?

Having a deadbolt lock problem can be frustrating, but it doesn’t have to be an impossible task. Door locks can malfunction for a variety of reasons, such as a damaged lock cylinder or broken pins. Fortunately, there are a few simple tools you can use to repair the lock yourself. 

(Searching in Google “car door lock repair shop near me“? Contact us today!)

Broken pins 

If you find that one of the pins in your deadbolt lock is broken, you should try resetting the pins. While doing so, be careful not to disconnect any wiring inside the lock. You can also take a photo of the pins’ internal gears to help you identify the problem and the correct solution. After the pins are properly replaced, you can reassemble the lock. 

If the pins are broken along the length, you may need to get a new one. However, you should not drill through the deadbolt lock if it is not broken on the front. The front pin is usually made of steel. You may need to use a larger drill bit to target the lock. Otherwise, you can try using a flathead screwdriver to twist the deadbolt. 

Rotating lock cylinder 

A deadbolt lock is secured to a door with a rotating lock cylinder. The lock cylinder is a cylindrical piece with a keyhole cut in the center. The key is held in place by pins on either side of the cylinder and releases when inserted into the keyhole. The pins and springs are positioned horizontally in the lock cylinder to prevent the key from rotating freely. 

Rotating lock cylinder in a dead bolt lock is made up of a pin and tumbler design. The key is inserted into the lock and aligns the pins, which in turn move a cam and bolt. The pins are in pairs along the length of the cylinder and rest on the bottom of the housing when the key is not inserted. When the key is turned, one of the pins pushes up and the other one goes down. 

Damaged set screws 

If you find a set screw in your deadbolt lock is damaged, you may need to repair it. To do this, you will need a drill and a set screw nut. You will need to drill the hole just enough to access the set screw, but make sure not to drill too deeply as this may strip the set screw. 

Damaged set screws on a deadbols lock are easily fixed. The screws that hold the deadbolt in place are held in place by two connecting screws. Usually, you can tighten these screws yourself, but you should have the right tools for this job. You can purchase these tools at a hardware store. 

Broken tailpiece 

A broken deadbolt lock’s tailpiece must be replaced. This is the part of the lock that connects the cylinders to the bolt. It must be rotated for the lock to be reassembled properly. Some tailpieces are “lazy,” meaning that they are easily turned by an outside force. If you have one of these tailpieces, you should not attempt to lock your door from the other side. 

Luckily, there are simple steps you can follow if your deadbolt lock has a broken tailpiece. First, make sure that the lock is installed correctly. When you’ve installed a deadbolt lock, you should check its installation. Make sure that it’s free of debris. It’s also important to check that the deadbolt retracts and extends as it’s supposed to. Broken parts can also be easily replaced.