How to Repair Snap Lock Flooring? 

Snap lock flooring is a type of floating floor that is made of planks that interlock near the edges. It does not use nails or glue, so if a board is damaged, it can be replaced without any hassle. However, if the problem is more serious, you may need to replace the entire floor. 

(Looking for keyless door lock installation service? Contact us today!)

How to Fix a Click Lock Flooring Issue

A common problem with snap lock flooring is that the boards do not stay in place. This is usually a sign that there is a manufacturing flaw or debris in the grooves of the floor. There are several ways to repair this problem, including cleaning the floors and replacing the board. 

The first step to repairing this problem is to remove the damaged board. You can do this by using a screwdriver or hammer to pry off the damaged section of the floor. 

Another way to remove the damaged piece of the floor is by cutting it off with a utility knife. This is a more time-consuming process, but it can be worth the effort. 

If the damaged board is a laminate one, you can use a putty or other wood filler to replace it. These products are available at most home improvement stores, and can be used to fill in small scratches and gouges on the floor. 

Before applying any putty or wood filler, make sure the area is cleaned thoroughly. This will help the new product adhere better. 

You can also paint a thin coat of putty over the scratched area and let it dry. This will seal the area and prevent further scratches from occurring. 

Depending on the brand of putty, you may need to repeat this procedure until the scratch is gone. Some kits come with a variety of colors to match the original color. 

How to Repair Bubbling on Laminate Floors

If you have laminate flooring that bubbles, the problem is probably an inferior product. It is best to replace the floor with a quality product that won’t bubble in the future. 

Once you’ve identified which board is causing the bubbles, remove it and replace it with a new one. This will ensure the floors remain solid and won’t become brittle over time. 

When you are removing the board, be careful not to damage it or break the surface of the floor. It is best to use a pry bar to help you pull it out of the crack. 

Then, you can lay a new board over the hole and re-install it in the same spot. To be sure you are putting the new board in the right place, it’s important to check that the boards line up correctly. 

To keep the joints from lining up, you should start the second row with a board that hits about six inches away from the end of the first board (and is also a minimum of 2 inches wide). Then, slip the tongue of the new board into the groove of the first board, and affix it by using a little bit of wood glue.